Ultimaker 2 Nozzle – Stainless Steel 0.50mm

 12.00  9.00 (Incl. tax:  10.89)

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass.

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

9 in stock

SKU: IdeaTo3d_850 Category: Tags: , ,


Ultimaker 2 Nozzle – Stainless Steel 0.50mm

The Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°c to 5°c lower because of this treatment, this is also usefull for oozing and drips.

With these special nozzles you can print faster, the plastic will flow much more easier than in classic nozzles. You can also clean them very efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colors or filament type is done faster and safer.

The special Stainless steel nozzle is built to resist to abrassive filaments

New diameter: 0.50mm!

Additional information

Weight 0.01 kg

Customers' review

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %


There are no reviews yet.

Be the first to review “Ultimaker 2 Nozzle – Stainless Steel 0.50mm”